msh />http_ota [http://iot.yizhongyun.com/Uploads/5e6dcff2d5f6f.bin](http://fdgdfg/Uploads/5e6dcff2d5f6f.bin)
http file_size:135356
[I/http_ota] Start erase flash (download) partition!
[I/http_ota] Erase flash (download) partition success!
[I/http_ota] Download: [====================================================================================>               ] 84%
[I/http_ota] Download: [=====================================================================================>              ] 85%
[E/http_ota] Exit: server return err (0)!

void HAL_UART_MspInit(UART_HandleTypeDef *uartHandle)
{
    GPIO_InitTypeDef GPIO_InitStruct;
    if (uartHandle->Instance == USART1)
    {
        /* USER CODE BEGIN USART1_MspInit 0 */
        /* USER CODE END USART1_MspInit 0 */
        /* USART1 clock enable */
        __HAL_RCC_USART1_CLK_ENABLE();
        __HAL_RCC_GPIOA_CLK_ENABLE();
        /**USART1 GPIO Configuration
        PA9     ------> USART1_TX
        PA10     ------> USART1_RX
        */
        GPIO_InitStruct.Pin = GPIO_PIN_9;
        GPIO_InitStruct.Mode = GPIO_MODE_AF_PP;
        GPIO_InitStruct.Speed = GPIO_SPEED_FREQ_HIGH;
        HAL_GPIO_Init(GPIOA, &GPIO_InitStruct);
        GPIO_InitStruct.Pin = GPIO_PIN_10;
        GPIO_InitStruct.Mode = GPIO_MODE_INPUT;
        GPIO_InitStruct.Pull = GPIO_NOPULL;
        HAL_GPIO_Init(GPIOA, &GPIO_InitStruct);
        /* USART1 interrupt Init */
        HAL_NVIC_SetPriority(USART1_IRQn, 5, 0);
        HAL_NVIC_EnableIRQ(USART1_IRQn);
        /* USER CODE BEGIN USART1_MspInit 1 */
        /* USER CODE END USART1_MspInit 1 */
    }
}